www.pairuigroup.com page: 1/3 date: 5/26/2014 dc-dc converter sip-package dae-1h series, 1watt, 6kvdc, unregulated features: 3 years warranty 6000vdc isolation voltage operating temperature range -40c to +85c low isolation capacitance model input voltage (vdc) output voltage (vdc) output current (ma) efficiency typ. min. max. DAE1-0511H 5(4.5~5.5) 5 20 200 80% dae1-0512h 9 11 110 80% dae1-0513h 12 8.3 83 80% dae1-0514h 15 6.8 68 80% dae1-0515h 24 4.2 42 80% dae1-0521h 5 10 100 80% dae1-0522h 9 5.5 55 80% dae1-0523h 12 4 40 80% dae1-0524h 15 3.3 33 80% dae1-0525h 24 2.1 21 80% dae1-1211h 12(10.8~13.2) 5 20 200 80% dae1-1212h 9 11 110 80% dae1-1213h 12 8.3 83 80% dae1-1214h 15 6.8 68 80% dae1-1215h 24 4.2 42 80% dae1-1221h 5 10 100 80% dae1-1222h 9 5.5 55 80% dae1-1223h 12 4 40 80% dae1-1224h 15 3.3 33 80% dae1-1225h 24 2.1 21 80% notes: other input and output models may available on reques t. electrical line regulation --- 1.2% load regulation 10% ~ 100% full load 15% max. ripple and noise --- 200mvp-p max. isolation voltage --- 6000vdc operating temperature range --- -40c to +85c mtbf --- 3.5x10 6 hrs
www.pairuigroup.com page: 2/3 date: 5/26/2014 dc-dc converter sip-package dae-1h series, 1watt, 6kvdc, unregulated electrical notes: all the data in this article are under test with ta+25 c, humidity<75%, rated input and rated load mode. mechanical 19.5 (0.768) 12.5 (0.492) 9.8 (0.386) 2.13 (0.084) 4.1 (0.161) 2.8 (0.11) connection pin # single dual 1 +vin +vin 2 gnd gnd 5 -vo -vo 6 nc com 7 +vo +vo note: * unit is mm(inch). temperature profile capacitive loads selection vin (vdc) cin (f) single output voltage (vdc) cout (f) dual output voltage (vdc) cout (f) 5 4.7 5 10 5 4.7 12 2.2 9 4.7 9 2.2 24 1 12 2.2 12 1 - - 15/24 1 15 0.47
www.pairuigroup.com page: 3/3 date: 5/26/2014 dc-dc converter sip-package dae-1h series, 1watt, 6kvdc, unregulated notes recommended test and application circuit in order to ensure the efficiency and dependability of the mo dule, the minimum specified load must be less than 10% of rated load. if the output power is low, we recommend to add an e xternal 10% loading resistor in parallel. fuse: depends on the actual input current; tvs: depends on the actual input voltage; recommended capacitor: c1, c2, c5, about 0.1uf; for c6, c7, p lease check the capacitive load; c3,c4: 2kv/1nf.
|